Clownmeat's build thread

[sandracer33]

https://www.ebay.com/itm/3-0-Billet...ash=item2cac1826c2:g:YBkAAOSwLs5XLO7f&vxp=mtr



There is a tube on the rear of the left valve cover that works nice.

Thank you!

Sent from my XT1650 using Tapatalk

 

[Scar_Tundra]

I know the Thread is dead for some time now. Im curious to how the motor is holding up. Looking to build my first T4R from a 3rd Gen. Issue, like most, is its under powered once lift and tires are added. I'm still in the research phase and undecided if I want to add boost or do a 2UZ swap. Thoughts and suggestions if you were to do it all over again...

 

[Clownmeat]

Engine is holding up just fine, still my daily driver. Not sure if there is anything I would have done different though, it's been good for over six years now.

 

[James082601]

Engine is holding up just fine, still my daily driver. Not sure if there is anything I would have done different though, it's been good for over six years now.

you still have that slushbox shifter?

 

[Myrunr2010]

Did you ever get around to finishing your 7th/8th injector setup and pumping up the boost?

 

[ebenditt1]

One big step forward, the circuit board is finally a reality! Used a combination of CNC milling and etching. Now just needs to be assembled.

This is very interesting I know that is an old post but it good to see a diy maker here helping us to see a better way to do something interesting and fun.

Also, if you don't know what is going on here please see the following youtube videos:

This
This

and

This

or

This

 

[Clownmeat]

Could of been worse I guess...

 

[Tucson4runner]

Not to bad at all. Looks like your bumper brace is probably still intact too. What happened?

Sent from my SM-N975U using Tapatalk

 

[Corey91mason]

Still re-read this post monthly troubleshooting my rear mount turbo. I went with the URD 6 injector kit and it has been brutal, considering going back to stock fuel/ecu and just running water/meth for 8psi. Seen a few that work, good to see yours is still plugging away.