I have a 94' 4runner 3.0 v6 manual with a new clutch and pressure plate and the tranny was just done last week.
So heres the problem:when the car is off it shifts into each gear fine but when the car is running everytime i push in the clutch it dosnt release it fully. And it wont shift into any gears. but i adjusted the clutch pedal rod to the master cylinder and it did help alot cause now it will shift into gears but it takes some muscle and it wont go into reverse. i was wondering if either the slave unit is known to go out or the master clutch cylinder. any help would be great! Thanks in advance!
So heres the problem:when the car is off it shifts into each gear fine but when the car is running everytime i push in the clutch it dosnt release it fully. And it wont shift into any gears. but i adjusted the clutch pedal rod to the master cylinder and it did help alot cause now it will shift into gears but it takes some muscle and it wont go into reverse. i was wondering if either the slave unit is known to go out or the master clutch cylinder. any help would be great! Thanks in advance!
