Coastal Offroad Rear Bumper Assembly/Install Write-Up

[ERMBPA]

Does anyone know if this kit went through revisions over time? Plate thickness, all the same? Reinforcing gussets on the back side?

Can a spare still fit underneath? One photo looked like the spare was under before the swing arm was installed.

Exhaust modification, needed to be tucked up higher or side exit?

I just posted about my bumper project, but not sure if it answers the design question. That may be a question for Coastal Offroad, who are good about answering questions in a timely manner. All the plate is very stout, they definitely did not cut corners on thickness.

The design of the bumper retains the factory location of the spare tire space. Before I completed my swingout I had a 285/70/17 under there.

Exhaust stayed in the same location, their design accounts for the rear most hanger.