deedubb
New member
I've tried searching but can't seem to find the answer here.
I attempted to install my cornfed 3/2 lift on my 07 SR5 but couldn't proceed because I couldn't get the steering knuckle bolt/upper ball joint to detach (forgive me if my names are off on parts here). I suppose I'll need a special tool of some sort. The other way I found to remove the shock/spring in one piece was to remove the upper A arm bolt (it's like a foot long) but there is no way to back it all the way out as it hits sheet metal after like 1 inch.
Am I making this too difficult? Any help would be appreciated.
Thanks,
Dave
I attempted to install my cornfed 3/2 lift on my 07 SR5 but couldn't proceed because I couldn't get the steering knuckle bolt/upper ball joint to detach (forgive me if my names are off on parts here). I suppose I'll need a special tool of some sort. The other way I found to remove the shock/spring in one piece was to remove the upper A arm bolt (it's like a foot long) but there is no way to back it all the way out as it hits sheet metal after like 1 inch.
Am I making this too difficult? Any help would be appreciated.
Thanks,
Dave
