Dash Lights and Tail Lights Out

[chaossd]

I installed some new LEDs in my license plate lights. One was on for 10 seconds before I swapped out the other, then the rear lights went out along with the license plate lights and my radio and dash lights (gauge lights still work and the A/C arrows still illuminate). When I hit my alarm, the license plate lights go on and the brake lights work fine too. Only when I turn my lights on at night do the dash lights and tail lights not work.

The question is, FUSE or RELAY?

If relay, which one is it?

I couldn't figure out which one it would have been, nor was I able to find a fuse that was out (I was searching in limited light).

Anyone else have this problem?

Any recommendations?

Thanks!

 

[drmorbius]

I installed some new LEDs in my license plate lights. One was on for 10 seconds before I swapped out the other, then the rear lights went out along with the license plate lights and my radio and dash lights (gauge lights still work and the A/C arrows still illuminate). When I hit my alarm, the license plate lights go on and the brake lights work fine too. Only when I turn my lights on at night do the dash lights and tail lights not work.

The question is, FUSE or RELAY?

If relay, which one is it?

I couldn't figure out which one it would have been, nor was I able to find a fuse that was out (I was searching in limited light).

Anyone else have this problem?

Any recommendations?

Thanks!

Replace the 10 amp tail fuse located in the lower dash. Check manual for exact location.