I'm new so I can't start a thread. Here's what I've done so far...
Replaced the rear tailgate latch actuator...was a $60 one from amazon, but had good reviews. I did the battery reset for 3 minutes, re-attach battery, lock/unlock all doors from drivers side 3x (did it without the key in), tailgate opens and closes - YAY.
Then I put the key in and start the vehicle. No rear defrost, no rear wipers, no tailgate window up/down. Tailgate won't open anymore. Turn car off. Take key out of ignition, do the lock/unlock 3x on drivers side door. Now the back tailgate will open again. WTH?
Can't use the key in the tailgate to try anything (we are at 320k miles, so we're way past key holes working).
Engine and dash ECU fuse looks ok...I think. I traded the 10 fuse with the 10 horn fuse and it didn't make a difference.
What am I missing?!
Not sure why the hatch wouldn't open again after starting the vehicle....BUT on the window not working...anytime you disconnect the battery you have to initiate the windows and moonroof functions again by.....hopefully this may help getting something working the way it should
To reset the driver's side power window auto-close:
1. Push down and hold the driver’s door power window switch to completely open the window.
2. Pull and hold up the driver’s door power window switch until the window closes. Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination.
3. Check for proper operation of the “one–touch open/close” by pushing the switch briefly to the “DOWN” and “UP” positions.
To reset the moonroof one-touch operation:
With ignition switch in the “ON” position, do the following:
1. Push and hold the “TILT UP” side of the switch until the moon roof tilts all the way up and then tilts down slightly (approximately 10 mm [0.39 in.] at the rear).
2. Check for proper operation of the “one–touch slide open/close” and “one–touch tilt up/down” functions by pushing the switch briefly to the “SLIDE OPEN” and
“TILT UP” positions.
To reset the rear window operation:
1. Turn ignition switch to the “ON” position.
2. Push the back door power window switch to the “DOWN” side to open the window.
3. Push and hold the back door power window switch to the “UP” side until the window closes. Continue holding it for approximately 1 second.
4. Check for proper operation of the “one-touch open/close” functions by pushing the switch briefly to the “DOWN” and “UP” position.