Diff Breather Tube Routing Locations (not gas cap)

[martini]

I just did the extended diff breather install the other day and I was trying to figure out where to route the tube to other than the gas cap. I ended up putting it next to the gas cap (seems to be the most common location) but I'm trying to figure out how to route it somewhere else (less visible).

I've seen on the tundra forum that some people have put it behind their tail light, I think I saw Thai put it behind his tail light and some have even gotten it into the location with the bottle jack. How do you get it up in there? Do you have to take off the tail light to get it in that general location? I found a little plug underneath near (has some wires going up through it from underneath) but I put a screw driver through it but couldn't feel it from inside the jack location.

 

[Thai]

I've seen on the tundra forum that some people have put it behind their tail light, I think I saw Thai put it behind his tail light and some have even gotten it into the location with the bottle jack.

I put it there on a 3rd gen 4runner (2002). So, i am not sure if the same applies to the 4th gen. I believe that i ran it BEHIND the rear bumper and then into the rear taillight housing. You can't see it when my cargo door is down. IMHO, this location is better than the gas cap location...for reasons already discussed in the other thread.

 

[Run'n'Gun]

The search link will be your friend. Read this thread. I put mine in the driver side tail light housing.
http://www.toyota-4runner.org/off-roading-home-monst4rs/123-breather-install.html