e-locker mod/pic request

[trd_4runnin]

Does anyone have a picture of what wire I need to actually ground? I have everything set up and ready to go, just don't know which wire to ground. I know that I need to cut the blue/red wire and I know that I need to ground the side coming out of the harness....just don't know which harness. The HBOSS write-up that everyone seems to have used is no longer there so I just need to know which harness to cut the wire from and I'll be good. Thanks@

 

[XJeepguy]

http://www.4x4wire.com/toyota/minutemods/greywire_mod/


I had this one bookmarked . Its for a Taco though . Ya thats to bad about the HBOSS page

 

[Rock Slide]

Don't know if you've seen these already, but they might be of some help to you:

Write Ups:

http://www.sonoransteel.com/phong/retrofit_electric_locker.html

http://www.4runners.org/writeups/elocker/


Wiring Kit:

http://www.offroadsolutions.com/products/new_products.htm

 

[trd_4runnin]

After a ton of searching las night, I was able to find the pin-out of the harness and a tiny picture to verify the correct harness. I got it done and it works except I noticed that my locker seems to engage much slower now then it used to. Is this typical of this mod, or is it because I was engaging the locker while driving on the street (under 5mph of course.)? I would have to idle forward very slow for about 20-30 feet before the RR DIFF LOCK light would go solid and I would hear it lock...

 

[LINY4Runner]

do you still have this pinout?

 

[Miyota]

Ok, so I know this is an old thread but never the less I need some clarity. I am trying to do this mod on my 2000 4runner with e-locker and I am finding some differences from my truck to this mod. When I pull of the kick panel on the drivers side I have a silver metal 4wd control box not black plastic. Also there is no blue/red wire coming from the harness. Any help as to what wire I should cut would be great. Thank you