Did a head gasket change on my 4.0L 2003 4Runner. Nearing complete, putting on the lower and upper intake manifold, but found a pair of brackets in the rear that I didn't label well. They're two brackets, each right near a pair of electrical hookups of some sort that I also need to pin down. Anyone recognize these and could give me idea of where they go? They look like they might be ground wires?
The first is about dead center between the two the heads. The other is back and to the left behind the right (passenger side) cylinder head. Would really appreciate your help to put this beast of a project to bed! Thanks!
The first is about dead center between the two the heads. The other is back and to the left behind the right (passenger side) cylinder head. Would really appreciate your help to put this beast of a project to bed! Thanks!
