If you are interested in aftermarket radios, you may want to wait...

HunterDonahue

New member
So I have been thinking about upgrading my 2015 Limited stock radio to an aftermarket radio but I had a few concerns. I was worried that it would make my car look stupid because it would not have buttons like the stock radio does. In the past, I have seen Tesla style radio's for Tundras but never any for a 4Runner. I found the company, Phoenix Android Radios, and looked for a radio for a 4runner. They did not have any so I messaged them because that is what they said to do if there is not a radio for your car. I did and they were quick to reply. They said :

Me:
Do you have a radio for a 2015 4Runner?
PAR:
Not yet
Me:
Will you be releasing one in the future?
PAR:
Have the plan. No set date though

Here is what the radio would likely look like (photo is in a tundra)
TB2SP9ramrDK1JjSZFLXXbk4FXa__0-fleamarket_1024x1024.jpg


So if you are thinking about aftermarket radios, you may want to wait.
 
Register to hide this ad
I researched these quite a bit for my RAM 1500 a few months back. They run an old android version that can't be updated. For some folks they run fine but for most there were just little quirks everywhere. For the most part they could get it to work but for what they cost the quirks were not worth it for me.

The one that was always a big issue was the call quality via bluetooth. They didn't use the OEM mic but one built into the face of the unit. Was pretty common for call quality to suck. A few people soldered in their own aftermarket external mic that fixed it but again, for the money you shouldn't have to. Maybe they finally just installed an external mic plug.

That being said, in the RAM it also had to control the heater and AC which caused more problems. The OEM head unit in a RAM 1500 is very integrated with the entire truck.
 
Someone else here was working with Phoenix for a stereo and there was no more progress, dont hold your breath

Sent from my SM-G930V using Tapatalk
 
Someone else here was working with Phoenix for a stereo and there was no more progress, dont hold your breath

Sent from my SM-G930V using Tapatalk

That was me in this thread. They want a 100 pre-orders before starting development.

More info in the thread.
 
My buddy has one in his tundra and is about ready to put his stock unit back in. Apparently it looks better than it functions.

I have a pioneer AVH1300 head unit in my Tacoma and I love it. Definitely putting one in the 4R soon
 
I have a 2010 SR5 and was wondering about asking the stealership about upgrading my stock stereo from when my rig was new to a stock stereo on today's 4Runners. I most certainly would rather ask you guys before asking blindly at the stealership. Like the OP, I would like my new stereo to be in congruence with the Toyota knobs and feel of the overall dash. Do you guys think it is relatively easy to walk into a Toyota dealership and get this older stereo modernized and still stay within Toyota, or have the vehicle layouts within the 4Runner 5gens changed so much since mine in 2010 that it would be relatively impossible? Hope all this makes sense.

Here is my rig as is:
 

Attachments

  • IMG_6614.jpg
    IMG_6614.jpg
    129.1 KB · Views: 2,205
I have a 2010 SR5 and was wondering about asking the stealership about upgrading my stock stereo from when my rig was new to a stock stereo on today's 4Runners. I most certainly would rather ask you guys before asking blindly at the stealership. Like the OP, I would like my new stereo to be in congruence with the Toyota knobs and feel of the overall dash. Do you guys think it is relatively easy to walk into a Toyota dealership and get this older stereo modernized and still stay within Toyota, or have the vehicle layouts within the 4Runner 5gens changed so much since mine in 2010 that it would be relatively impossible? Hope all this makes sense.

Here is my rig as is:

There are several routes you can take, but none are going to give you what you want.

If you go with an aftermarket Head Unit, you're replacing the dash kit as well, and I'm not aware of any known solutions for dash kits with knobs (or aftermarket HU that use the Toyota knobs).

You could take a used stock HU from someone who is replacing theirs with an aftermarket piece and new dash kit. You can probably get it for cheap and it should integrate into your setup without many hiccups, unless there are changes between your model and later models. Then you'd potentially have an entune touchscreen display, but you're still stuck with the same problems everyone else has (no car play, etc; entune sucks, etc).

Read up what others have done here with head units and stereo replacement, and tell us what you end up doing.
 
There are several routes you can take, but none are going to give you what you want.

If you go with an aftermarket Head Unit, you're replacing the dash kit as well, and I'm not aware of any known solutions for dash kits with knobs (or aftermarket HU that use the Toyota knobs).

You could take a used stock HU from someone who is replacing theirs with an aftermarket piece and new dash kit. You can probably get it for cheap and it should integrate into your setup without many hiccups, unless there are changes between your model and later models. Then you'd potentially have an entune touchscreen display, but you're still stuck with the same problems everyone else has (no car play, etc; entune sucks, etc).

Read up what others have done here with head units and stereo replacement, and tell us what you end up doing.

Replacing with a more modern (2014-2015+) HU seems to be the easiest way out for you indeed. You will find loads of them for sale for cheap. Or jump straight to an aftermarket Pioneer(or equivalent) HU.
 
Replacing with a more modern (2014-2015+) HU seems to be the easiest way out for you indeed. You will find loads of them for sale for cheap. Or jump straight to an aftermarket Pioneer(or equivalent) HU.
I thought I read somewhere that they are interchangeable unless you want to mess with rewiring some things.
 
Replacing with a more modern (2014-2015+) HU seems to be the easiest way out for you indeed. You will find loads of them for sale for cheap. Or jump straight to an aftermarket Pioneer(or equivalent) HU.


I thought I read somewhere that they are interchangeable unless you want to mess with rewiring some things.

seems like he'd need the dash too; I assume the wiring is straightforward, but not like i've done this swap
 

Members online

Forum statistics

Threads
278,315
Messages
3,554,131
Members
248,016
Latest member
Advally Service

Trending content

Back
Top