Master Cylinder Replacement

[FirstGenRunner]

I've searched around a bit but haven't found the answer I'm looking for, so I apologize in advance if I missed something.

I'll be replacing the brake master cylinder this weekend. The FSM says to adjust the brake booster push rod with SST - 09773-00010 (Brake Booster Push Rod Gauge). Looking at the pic of it in the manual I understand what it's doing, but can't think of a tool or a way to adjust this correctly (or really, easily) without this tool. My question is whether anybody knows of a way to do this without purchasing the gauge.

Thanks in advance.

 

[fourwd1]

You shouldn't have to adjust it.
Just replace the MC and make sure you bench bleed it before installing it.

 

[the_dingman]

If you do have to adjust it, all you need is a wrench and pliers.

 

[FirstGenRunner]

I purchased an after market MC, which I feel like are never quite close enough. Thanks for the info, since I'm trying to make sure I have all my bases covered.

I know the FSM says you're not supposed to have any gap between the push rod and the piston, I wanted to make sure it wasn't the other way and shortened the piston's travel.

Again, thanks for the info.

T