My first 4Runner

[Redneck92]

Just bought her today. Gotta do a few things before I start driving it everyday. She drove good on the hr+ drive home though. Gonna get a new windshield, bed liner int, a few int mods, 2" body lift, and a lil mor lift in the rear. Also I'm new to this fourmn seems like a pretty good place so far.

 

[90toytruck.]

nice rig and welcome

 

[fourwd1]

Welcome to T4R

 

[Badwolf]

Nice looking rig. Looks like someone put some time into her already. Good luck with it.

 

[Redneck92]

Nice looking rig. Looks like someone put some time into her already. Good luck with it.

Yeah they did but I have a few plans for it. Any suggestions on more lift. The rear needs springs cause I hate blocks.

 

[T?@\7]

welcome, nice looking truck.

 

[Barnaby]

I went this route to raise the rear of mine. 1st Gen 4Runner ZUK Mod DIY/How to (Lots 'o' photos!) - YotaTech Forums

Well almost anyway. I welded up both of the mounts instead of this method but the end result was the same. Total cost was <$100.

 

[Redneck92]

I was wondering if I could use the 1.5" ball joints up front with a little t-bar adjustment to get about another 2" of lift out of the front. The only thing I was worried about was the cv angle, I think It might be a little to steep if I do that. The rear I was gonna swap sprng for something out of a 1/2 truck I I can find the right ones. I know My buddy said something about Bronco II rear leaf lift springs would work. Either that or just get some more leafs and rebuild the stockers and get rid of those blocks. My only self debate now is weather to go with a 2" or 3" body lift.