Need help in finding a bolt size (front bumper)

[Longhorn425]

Hey guys,

Planning on installing a c4 lo Pro bumper this weekend and to my surprise, I’m missing these bolts.

Does anyone have the specs for these they could provide so I can pick them up at a hardware store?

C4 Fab Lo Pro Bumper Install 5th Gen 4Runner - Trail4Runner.com

Looks like Toyota doesn’t give that info out

91554A1025 - Bolt, flange. Interchangeable with 90105a0239 - Genuine Toyota Part

 

[ryguytheman]

M10 flange head I believe, not sure on the length. But if you overshoot the length a bit it shouldn't matter, the end will pass through.

FYI, I had a hell of a time trying to get one of those bolts out when removing the original crash bar. I broke a wrench, stripped the bolt... Blow torch is your friend there, using that from the start would have saved me a couple hours of tinkering.

 

[Longhorn425]

Good to know! Thanks for the advice!

Update here as well. I was able to locate these at a nearby Toyota dealership. It was $14 for all 6, and I figured $14 was low enough to save my time on trial and error in the Home Depot parking lot.

 

[MeefZah]

Good to know! Thanks for the advice!

Update here as well. I was able to locate these at a nearby Toyota dealership. It was $14 for all 6, and I figured $14 was low enough to save my time on trial and error in the Home Depot parking lot.

That was smart because, IIRC, those bolts have a different pitch from your "normal" 10mm bolts... I want to say 1.25, maybe? I had to make a few trips.

 

[phillyd2]

OK, I have to ask. How the hell are you missing those bolts?

 

[Longhorn425]

OK, I have to ask. How the hell are you missing those bolts?

I actually sold them by mistake when I sold my old bumper ��

 

[osteograf]

These are M10-1.25