Car Pirate
New member
So a few weeks back I was being incredibly stupid and drowned my beautiful 05 v8 in 5 feet of water and long story short replaced the engine. I ripped the wiring out of the o2 sensor (4 wires) when I pulled the old engine out and I’m not sure which goes where on the o2 sensors clip. On top of that the center diff is stuck on (4lo was as well but I unbolted the actuator some and shook it around which fixes that but not the diff). I’m thinking of putting the fj transfer case in if I can’t figure out a way to unlock the diff, any tips? I know the rear drive shaft has to be extended but is the yoke long enough to where I could go without extending the shaft at least temporarily? Ideally I would want to keep the current transfer case and AWD but I think I’m at the end of the rope here.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
