Rear King Shocks for 3" OME Springs

[chmura]

I got off the phone with Downsouth Motorsports.

I want to purchase medium OME 2889 3" springs and rear King shocks for a 2018 non kdss 4runner.

King does not make a off the shelf rear shock for a 3" spring only for a 2" rear spring. In order to run this spring I need to get a shock custom built by King. I need to give Downsouth Motorsports the measurement for this setup. Has anyone taken this measurement before?

Doing a search on this forum many people run a 3" OME springs with King shocks.
So I am assuming many people on here are running the incorrect rear length King shock for a 3" OME rear coil??

 

[chmura]

Anyone? 3" OME coil is popular on this forum.

 

[kso818]

Contact Filthy Motorsports. They might already have the measurements that you would need.

 

[ayeyothisiskyle]

From filthy.

"n the rear, depending on your desired stance, 1.5” rear spring spacers are a simple solution, yet the rear will still sit a bit lower than the front at stock weight and will look sagged under a moderate load. Most customers end up going straight to a 3” rear spring, that nets about 2” of lift under a typical load and levels the body nicely. If you plan to go up to 33” tires down the road, this setup requires 2” bump stop spacers and custom length King shocks to maximize full available suspension travel. Otherwise, if you stay with factory tires, the bump stop is not needed and we can work with the standard rear King shocks."

 

[tristero]

bimrunner and califab figured out the King rear LT, scour through his thread. I think they are based on the Tundra shocks

Bimrunner Build Thread & Pics