Rear upper control arm bracket

[Beagle(4)Runner]

Searched on line with no luck. While installing 3' lift on my 99, i noticed that the rear upper control arm bracket on the passenger side was cracked and rusted, PA winters. Does any one know where I can get a replacement bracket to weld on. I have someone who can weld it on, i just need the bracket.

 

[Scramble]

Searched on line with no luck. While installing 3' lift on my 99, i noticed that the rear upper control arm bracket on the passenger side was cracked and rusted, PA winters. Does any one know where I can get a replacement bracket to weld on. I have someone who can weld it on, i just need the bracket.

I've never seen them for our trucks, they do make them for Jeeps. You'l probably have to have it fabed up.

 

[snivilous]

I would just weld the crack, maybe plate it if it's bad. Nothing fancy about those mounts.

 

[Rifter]

Had the same issue with my used 4runner, had already been repaired once so had to replace mount. My mechanic fabbed one up and installed it for $500. It looks at least twice as strong as the factory mount so im sure it will last.

 

[wc11]

Just happened to me. Passenger side rear upper broke right off.
Off to find a welder....

 

[CbRoo22]

My new-to-me '99 has a snapped off upper control arm mount. Was a NY truck. What it was attached to doesn't look too great, so maybe I'll just swap in a whole axle if welding is going to cost similar $