Stock Body bolts and bushings

[sam24th]

So I bought my 1st gen 4runner awhile back and the previous owner had installed a 3inch bodylift on it. Not a huge fan of them so I am wanting drop it down a bit. So now I need the stock size bolts and bushings, I just want all new hardware. Wondering where the best place is to buy them if anyone has experience with this.

 

[4runnerBrett]

M10 -1.25 and 3 inches long I would go with grade 8 and any home depot or hardware shop. I believe its 10 bolts you need.

 

[sam24th]

Damn just got back from HD and holy crap I think ill look online for some bolts. They are expensive there. The bolts themselves were $7.50 a piece and the nut was $1.25 each. Not to mention i still need bushings and washers.

 

[Pisa 8687]

Damn just got back from HD and holy crap I think ill look online for some bolts. They are expensive there. The bolts themselves were $7.50 a piece and the nut was $1.25 each. Not to mention i still need bushings and washers.

You shouldn't need anything but bolts if the 3" body lift was installed right. All you do is take out the 3"spacer and then use the washers and small stock rubber mounts that should still be right in place. If you buy the right bolts you can even reuse the nuts.

 

[sam24th]

Well it was installed correctly, but the bushings are looking crusty, actually one of the front bushings where the rad support is, is falling apart. The bolts are pretty rusty also and I rather just get all new hardware. I did a little searching though and seems like 4crawler has what I need for a reasonable price. Im gonna shoot him an email here shortly.

 

[papawhellie]

Couple suspects..

Bolt Depot - Nuts and Bolts, Screws and Fasteners online

Hex Nut - Carriage Bolt - Brass Fasteners - Fastener Supply - Threaded Inserts | Albany County Fasteners

I have found these two prices to be as competitive as it gets.

 

[Pisa 8687]

Well it was installed correctly, but the bushings are looking crusty, actually one of the front bushings where the rad support is, is falling apart. The bolts are pretty rusty also and I rather just get all new hardware. I did a little searching though and seems like 4crawler has what I need for a reasonable price. Im gonna shoot him an email here shortly.

You can't go wrong withe the 4crawler guys. There stuff is great.