jstim
New member
Maybe this should be a sticky...not too sure. You tend to see a few of these here and there. Some of us more experienced than others in this, but even with my experience I still ask second opinions and if anyone can do a VIN check.
Anywho.....its a 2002 SR5 Silver.
The Good- Body is solid, little surface rust where the back bumper was hit. Looks like it was a minor fender bender, no body damage aside from the bumper touching the body itself. Solid clean frame...check.
The Bad- It does have some maintenance things that need to be addressed. I know just looking at it, valve cover gaskets, timing belt and water pump, upper and lower ball joints, inner and outer tie rod ends, shocks, struts and needs a alignment bad. AutoZone pulled 3 codes, the infamous P0446 x2 and P1135. Oh, and cosmetically need a passenger side mirror housing.
It has a shake between 60-70 mph. I can't tell if its because it needs new rotors, or its just part of the alignment and maintenance needs.
VIN - JT3HN86R4290614444
The plan is to go with Tundra struts up front, LC shocks in the rear, level, no rake. This rig is going to be my girlfriends DD. I am going to do all the maintenance myself except for the timing belt, and I know thats about $700. He's come down from 4k to 3500. Thoughts on where to go from here.
Edit- [MENTION=44220]BigFishAllDay[/MENTION] you have resurrected a few and built one for your wife....what do you think?
Anywho.....its a 2002 SR5 Silver.
The Good- Body is solid, little surface rust where the back bumper was hit. Looks like it was a minor fender bender, no body damage aside from the bumper touching the body itself. Solid clean frame...check.
The Bad- It does have some maintenance things that need to be addressed. I know just looking at it, valve cover gaskets, timing belt and water pump, upper and lower ball joints, inner and outer tie rod ends, shocks, struts and needs a alignment bad. AutoZone pulled 3 codes, the infamous P0446 x2 and P1135. Oh, and cosmetically need a passenger side mirror housing.
It has a shake between 60-70 mph. I can't tell if its because it needs new rotors, or its just part of the alignment and maintenance needs.
VIN - JT3HN86R4290614444
The plan is to go with Tundra struts up front, LC shocks in the rear, level, no rake. This rig is going to be my girlfriends DD. I am going to do all the maintenance myself except for the timing belt, and I know thats about $700. He's come down from 4k to 3500. Thoughts on where to go from here.
Edit- [MENTION=44220]BigFishAllDay[/MENTION] you have resurrected a few and built one for your wife....what do you think?
Last edited: