Trd fox eibach springs

[crawlingjunk]

Could someone who has installed trd fox eibach springs take height measurements for me?
Front and rear. Center of the wheel cap to the bottom of the fender
Thanks


Sent from my iPhone using Tapatalk

 

[crawlingjunk]

Bump


Sent from my iPhone using Tapatalk

 

[M_RED]

I have the Eibach springs with a 0.25" spacer on top of the strut on the front of mine, and Eibach load-lever (+250lbs) on the rear sitting close to the top of the perch... is that useful info for you, or too far a departure from what you are looking for...

I had a spread sheet once of google search results of this exact question... I'll see if I can dig it up

 

[crawlingjunk]

Still looking


Sent from my iPhone using Tapatalk

 

[wcslv]

I have had the springs for 10 months now 19 Pro. I just measured the height drivers front 21.75, passenger front 22, drivers rear 22.75, passenger rear 23. I have a full tank of gas, RCI rock-sliders, aluminum skid plates, and a Smittybilt 2781 air compressor mounted in the engine bay on the driver side.

 

[crawlingjunk]

I have had the springs for 10 months now 19 Pro. I just measured the height drivers front 21.75, passenger front 22, drivers rear 22.75, passenger rear 23. I have a full tank of gas, RCI rock-sliders, aluminum skid plates, and a Smittybilt 2781 air compressor mounted in the engine bay on the driver side.

Thank you! Exactly what I was looking for


Sent from my iPhone using Tapatalk

 

[Zal4R]

I have had the springs for 10 months now 19 Pro. I just measured the height drivers front 21.75, passenger front 22, drivers rear 22.75, passenger rear 23. I have a full tank of gas, RCI rock-sliders, aluminum skid plates, and a Smittybilt 2781 air compressor mounted in the engine bay on the driver side.

Do you still have the pro rack? What’s the height to the top? Wondering if it will still fit in the garage.

 

[wcslv]

79 1/8” at the highest point which is the knobs for the top cross beam.