kevinb_NJ
Member
Crossing my fingers!
Really keeping my eye on this thread. I have a similar wobble at highway speeds. Have had the tires balanced 3 times with no success.
Crossing my fingers!
Really keeping my eye on this thread. I have a similar wobble at highway speeds. Have had the tires balanced 3 times with no success.
if you're referring to the steering wheel wobble at certain speeds, i fought this for quite some time and have finally had it sorted. i have aftermarket wheels with an agressive offset and relatively heavy 285 tires, which definitely magnified the issue. the remedy for my 4r was getting the tires road force balanced by someone who knows what theyre doing (this was surprisingly hard to do in my experience) + having the wheels torqued to spec off the ground. The latter part matters. Even after having my tires balanced a couple of times by a good tech, there was a bit of vibration at highway speeds that got worse with any mud on the tires. having the wheels tightened off the ground took all of the vibration away, even after driving in mud.
And here is another issue about wheel torque
NHTSA ID Number: 10132884
Manufacturer Communication Number: T-TT-0424-16
Summary
TT: Front Brake Vibration Key Points: * Issue can occur at any time if improper torque is applied on lug nuts * Over time, even one lug nut over or under torqued, can cause a vibration issue * When lug nuts are over torqued, this causes the rotor to have a runout out condition which can lead to brake vibration concerns * Brake vibration issues can occur at parking lot to highway speeds * Brake vibration issues can occur at light to moderate braking * Tightening lug nuts in a star pattern method during the torqueing process will assure that even/equal pressure is applied across the rotor hub surface * Torque sticks/wrenches should be used to apply accurate torque values when tightening * Do Not use impact guns/ratchets to completely run lug nuts up to the wheel surface
not what i was referring to
STill waiting on an answer from my dealer. Have had both front and rear diff replaced on my 2017 Limited and the same problem exists. Left two messages for my service advisor.....think he’s avoiding me.
I'll throw in my anecdotal experience.
I installed the ECGS bushing on my 2010 TE, and it did not get rid of the 50-60 wobble. I did not have the "cyclical" grinding issue, I was hoping to eliminate the 55mph vibration.
I think its important to separate the two symptoms.
Finally spoke to my dealers service manager and he is having Toyota’s regional engineer/tech take a look at it in mid March. Hopefully the problem can be located and fixed.