What is this part??

[That_Titanium_4RNR]

Any ideas? It's in the way when I tried to install my Powertrays with RTMR.

 

[Inv4drZm]

Any ideas? It's in the way when I tried to install my Powertrays with RTMR.

I forget what it is but I just removed the fender bolt and bent the bracket downward until its completely flat with the ground, 90 degrees from where it is.

I don't think I even had to cut a relief to bend it I think it just bent at a weak spot.

This gave me enough clearance to mount my switchpros bracket that I built YMMV.

 

[That_Titanium_4RNR]

I forget what it is but I just removed the fender bolt and bent the bracket downward until its completely flat with the ground, 90 degrees from where it is.

I don't think I even had to cut a relief to bend it I think it just bent at a weak spot.

This gave me enough clearance to mount my switchpros bracket that I built YMMV.

I was thinking about doing something similar, no issues thus far? Didnt want to disrupt any sensors etc

 

[Inv4drZm]

I was thinking about doing something similar, no issues thus far? Didnt want to disrupt any sensors etc

It a resistor or something like that so haven't had any problems just make sure you don't stretch any wires.

 

[techno]

It's the air injection control driver.

 

[That_Titanium_4RNR]

It's the air injection control driver.

Thanks alot man!