What's on your molle panel?

6-30 round magazine pouches, 2-grenade pouches, 1-IFAK, 1-canteen pouch, 1-radio pouch, seatbelt cutter, knife, GPS and a small pressure switch red light... oh, your talking the window grills.:bounce:
 
how in the hell do you see through the g33 magnifier? you have to basically have your eye touching it to get any sort of good eye box out of them. we have always had to run them very far back. its one of my least favorite things about a g33 magnifoer.

i have a sps tac with seekins rings and a larue base. no bedding needed on the base or anything, perfectly flat right out of the box. the seekins rings are some of the nicest you can buy. i would put it right up there with sphur. i honestly think my sps tac is a half moa gat at 100 yds due to my glass/ring/base setup. if you want to make one jagged hole, youre gonna have to pay.



I can see mine alright at the distance it’s at... for now my eyes are good so I only use it on occasion.


Sent from my iPhone using Tapatalk
 
68ba33e2cbd85c07221db5753c2dcf69.jpg
2294834ded48f21e31deee2d0d5e6af5.jpg



Sent from my iPhone using Tapatalk
 
How do you attach the gear so that it doesn't become a missile in the event of a front end collision? Is it more than velcro? It would be a shame to have a 30 mile an hour fender bender end up with a hatchet in the back of the head!

While I don't have a hatchet I do have a machete. I have it attached with Velcro straps around the sheathing and face with the handle at the rear (collision wont dislodge blade this way). The hatchets have strong clasps around the handle, usually a sheath and bolt to the panel.
 
Any company's that make them so they fit more into the window and not so over sized?

Is Victory the only company that makes these?
 
Any company's that make them so they fit more into the window and not so over sized?

Is Victory the only company that makes these?

i suspect it makes making the mounting brackets easier. i also would think you would want a piece of metal like that that has no problem smashing through a window atleast a couple of inches off the window. im sure it also makes weaving the molle through the panel much easier as well.

i think there are a couple and it may depend on what generation runner you have. i know rango makes some as well.

i had looked into these somewhat heavily until i noticed all the options i were looking at required me to modify my interior panels. im not willing to do that right now, but maybe down the line when i get brave enough to try my interior sleeping situation and possibly need more room to organize stuff.
 
These would be really useful but I don’t know if I can lose the cargo cover. Out here, people will break into your car for $0.25 and a hoodie.
 
These would be really useful but I don’t know if I can lose the cargo cover. Out here, people will break into your car for $0.25 and a hoodie.

one could also argue that a cargo cover could potentially invite more thieves if they think you are hiding something valuable. its not like these cars are hard to get into.

i know sacramento very well. yes there are pockets where i wouldnt want to do anything other than drive through it, but you shouldnt be leaving a car with valuables in it with a poor security system in bad places. honestly, id be more worried about getting my cat cut out and stolen.

ive had people break into my car and not steal anything, although they did F up a lot of my interior panels. i have however had someone steal a cat on a previous truck (same vehicle that was broken into).
 
Last edited:
one could also argue that a cargo cover could potentially invite more thieves if they think you are hiding something valuable. its not like these cars are hard to get into.

i know sacramento very well. yes there are pockets where i wouldnt want to do anything other than drive through it, but you shouldnt be leaving a car with valuables in it with a poor security system in bad places. honestly, id be more worried about getting my cat cut out and stolen.

ive had people break into my car and not steal anything, although they did F up a lot of my interior panels. i have however had someone steal a cat on a previous truck (same vehicle that was broken into).

No one pays attention to car alarms so a security system is a waste of money.
The cover won’t keep away some thieves but it might keep some semi-honest people honest.
 
I just added a driver's side Orange Boxx PSD & Recon rack in my 4Runner. On the main PSD I have an automotive/Marine fire extinguisher, hatchet, 7" folding saw, e-tool, roll of Gorilla Tape and 14" zip ties. On the Recon rack is a 285 piece first aid kit and recovery strap. More items will come as I need them. All items are secured with 75lbs zip ties so they don't become projectiles in the event of a crash. I also placed the fire extinguisher toward the back so e of the Recon rack so it is braced against the long mounting bolts. The e-tool is under the Recon rack and between all the mounting bolts. This should help keep them in place or deflect them as well.
 

Attachments

  • A6DE6DB8-6F28-4AE3-AE93-6F652688F92A.jpeg
    A6DE6DB8-6F28-4AE3-AE93-6F652688F92A.jpeg
    99.6 KB · Views: 1,317
  • 2E416A98-FD83-4E0C-91C9-205F3D3D5E24.jpeg
    2E416A98-FD83-4E0C-91C9-205F3D3D5E24.jpeg
    104.5 KB · Views: 1,256
Love the look of these panels but cant justify paying what the people making them are asking for. Ordered a cloth molle panel on amazon for under $20, gonna attach it to an aluminum panel for rigidity, should work just fine for me. Unfortunately wont be home till July, I'll try to update how it looks and works once I get it installed.
 

Members online

Forum statistics

Threads
278,316
Messages
3,554,107
Members
248,016
Latest member
Advally Service

Trending content

Back
Top