Wheel Question

[Jacktalkssmack]

I bought a "new" 3rd gen limited 4runner recently, it will be primarily a road vehicle.. shame..

Anyways I was wondering if I could throw the new 4runner wheels on my rig

Hubcap Haven: ALY69561 Toyota 4Runner Wheel Charcoal Machined #4261135440

those bad boys..

Has anyone done or seen this? will I need some spacers or anything?

Thanks in Advance!

 

[AZ4FNER]

I have no idea, but I think you will not get a lot of feedback on rolling 20's.

Aren't 17's big enough?

 

[SCRunner12]

You might need a small spacer but I don't think so. It'd be interesting to see.

 

[Jacktalkssmack]

AZ - what do you mean by response?

As mentioned it will be a road vehicle, no plans to lift or anything as it will be my work car..

It will be entirely for looks haha

 

[4Running Daily]

Do it. Go out and try!

Then sell me your old rims

 

[Hepar]

AZ - what do you mean by response?

As mentioned it will be a road vehicle, no plans to lift or anything as it will be my work car..

It will be entirely for looks haha

I think he was probably saying that most people on here think anything above a 17" wheel is too much wheel for these rigs. They're not the biggest things on the road, so it's not hard to have a wheel take up a lot of it. That being said, I think it is a clean wheel. What size tire are you thinking of running with it?

 

[Jacktalkssmack]

I dont know what size tire I would throw on them, obviously something with a low profile..

Any ideas?

 

[CodyX36]

Probably 235/30/20. Then again, you'd probably be better off asking a Cadillac owner with the stuff you're trying to throw on there...

 

[splinter]

30 series would be on a car not a truck.
width x sidewall x 2 / 25.4 + wheel size
example 235 x .30 x 2/ 25.4 + 20 = 25.55 tire heigth