Wiring Question

[Maxil]

I am attempting to hook up a brake controller for a trailer with brakes on it. It's going well so far, but the 1 brake line that runs from the front to back has me stuck.

I am running this line from the engine compartment up under it, it goes well until I reach the rear wheel well. I can't find a safe place to run the wire to get it to the back bumper.

Anybody know a good way to get past the rear axle, suspension and everything back there?

Thanks a bunch,
Maxil

 

[athlon450]

Check these videos out!
YouTube - Trailer Brake Controller Installation - 2008 Toyota Tacoma - etrailer.com

 

[athlon450]

Just finished my father's trailer brake install. I just followed the routing of the factory wiring harness that goes from the front to the rear and zip tied in to the harness until I reached the back!

 

[Maxil]

Thanks for the help, I got the brake line run now...phew. Now where in the world is the line that comes on when the brake is pressed, should be near the brake pedal? I looked for it, but what I think it connects to is a cylinder up high on the left side of the dash, it hasn't got much line there either.

Thanks!