Recent content by 96pearlrunner

i get a conservative 170miles out of a full tank supercharged on 285/75R16 KO2. Five O Motorsports Injectors, new genuine toyota fuel pump and filter. I've learned to accept it over the years. it hurts driving it with the rising gas prices. MPG is literally the same as when it was naturally...

I'm helping a friend figure out a problem with his 84 22r pickup. Headlights work. With key on, nothing comes on. There's no power with key on ACC. Radio doesn't come on. No Start/Crank. Replaced the ignition switch with a new one and still nothing. Please help. There is battery voltage at the...

Using FelPro MLS Headgasket. Doesn't say anything about specs. Yes using new head bolts.

Anyone know if the torque spec is the same for the MLS head gasket for the 5vzfe? I know the fsm is calling for 25ft/lb, 90 degrees, and additional 90 degrees but with the factory graphite headgasket.

it threw a p01135 code for a/f sensor heater circuit malfunction. I replaced both the a/f sensor and downstream sensor. CEL still came back. I haven't had a chance to scan it again. I'm curious to know how the a/f sensor plays a role in vehicle stability control. I would imagine bad wheel...

Like the title says. Got an 01 4runner with the vsc lights on. what causes it and how do I go about fixing it. I've googled it and found some people saying that it could be from a gas cap to mass air flow sensor to cat coverters. I'm lost. anyone with some advice.

C clips? There's no c clips. I'm not doing a ball joint. i'm just seperating the spindle from the upper control arm but cant get the ball joint to move.

yes I've tried there and the little nub right below it too. I tried hitting upwards on the upper control arm also with pressure.

i was trying to avoid taking it to the machine shop to get it pressed out. i was hoping there was a different method but it seems like i'm kinda out of choices

Like the title says, I've tried everything. I've banged it from every angle and every position with the mighty thor hammer. I tried prying it apart with a large pry bar and a 2 jaw puller. I tried the puller and hammer combo and still didnt work. The ***** is on there good. Any advice please?

SpidermanGeek what thickness plate are you using

My brother has an 89 Auto 3.0 4runner and we're looking to swap the transmission as it has been having alot of shifting problems and the trans fluid is black. My situation is can the 90-95 Automatic transmission be used. I understand it will bolt up but I heard there were a slight difference in...

I got it figured out. the powersteering tensioner pulleys uses a replaceable bearing(Napa Part Number: 62042RSJ) and the a/c idler pulley is the one autoparts store carry.

I'm trying to swap out my idler pulleys on my 94 22re but i want to know if there is a difference between power steering idler pulley and a/c idler pulley. Autozone carries one idler pulley, Napa carries one idler pulley, and Oreilly's carry just one idler pulley. I noticed one was bigger than...

I'm looking into the front setup and I'm trying to settle on the Tundra 5100s/TRD Coils but somethings holding me back. I'm looking to get 2.5" of lift in the front. WheelersOffRoad's website says the strut setup should give me 0-2.5" of lift depending on the settings. I'm assuming that the top...