Recent content by c0mmon

I had this problem as well, I bought a specialty socket made for Grabbing it, hammered it on gently, and it worked perfectly got it from MSC, had a spiral shape inside and fairly sharp -was like 25 bucks but worked like magic http://www.mscdirect.com/product/details/02108009 like that

Thanks, what did you use to tap it in? I dont have the SST"" and dont intend ot buy it for this hopefully 1 time job

Going to do my rear main seal, while ive changed the transfer case this is an astronaut journey for me. Anyone have a good guide that outlays everything? hoping to learn steps tools needed what i should replace while I have it out anything that can help really, going to be a PITA. On that...

I purchased a driveshaft bolt for my 4runner. I had lost it because I had to swap driveshafts in the grass at a location. Not only is their lead time ridiculous. They ordered the 13mm 3 times instead of the 14mm. When it came I installed it, taking it off a few months later, 7 bolts...

plan on checking it tomorrow, im thinking t case mount 2 also by some chance. really thinking driveshaft balance scared of it. going to tighten everything up tomorrow again

Hi Guys, Installed the new transfer case with 1 pair of ramps in a dirt parking lot and some hand tools( no freaking fun ) Either way - 2 issues now 1) at 70(exactly) floor vibrates 2) when you first take off it squeaks. I had the rear ujoint replaced with a Moog HD-the front were checked...

ok, so i finally got it started after transfer case change, may this never happen again I did it in the mud with some ramps it sucked and a few days were after rain. Anyway, I couldn't get it started and found out why. My P-R are both reverse N is actually park D is actually Neutral and 2nd I...

So a little yank is all you are saying? Figured but did not want to test it angle is all the same

Hi Guys, So I am replacing my transfer case in my 97sr5 and while everything is 90% done the front drive shaft is ~2 inches short. I did not change the lift anything and replaced with a similar year similar function drive shaft. The rear went on perfectly. how do I fix this problem?

Hi Guys, I am putting in a new transfer case currently, the one I just received had the cup (ring) that holds the ball to the transfer case lever was broken in pieces. Is there a part number for this>?

*buys a lottery ticket*

Hi Fastllife. Interesting to see you on this forum now. If you need me to look at one in South/Central NJ I tend to have time on Saturday morning. What happened to that 1999 with all the service records i showed you? This one has potential to be nice for its price...

Thanks for the tips, ill make certain to post any head lumps for your entertainment. :hello:

Hi Folks, Replacing my Transfer case due to a crack (not the most fun). Either way does anyone have a write up on disconnecting the drive shafts from the transfer case? I disconnected the 4 bolts on each that connect to it. but getting any wiggle out of that is just not going to happen it...

Says they are 6 lug off a Taco-16'' whees. Can anyone ID off that picture/know if they would clear 231mm tundra brakes?