Recent content by Ekimrm

I have a 1990 runner with a v6. It is 4 wheel drive. Friday I changed oil in it. Nothing looked out of the ordianry. Drove It a little this weekend and everything seemed fine. Driving to work today and it started knocking horrible. I thought maybe I forgot to out the plug back in or something. I...

Thurio that is almost exactly what I had in visioned. Rock well this morning it was 28 degrees. As much as I could probably muscle through it, my 3 yr old daughter might have a slight issue with it. Silly kids they take all the fun out of everything.

I am looking for some ideas. What I want to do is strip all the interior out of the back half of my runner. Along with that would be stripping all the carpet out and laying down a coat of the bed liner spray throughout all of the floorboard. The back half is what I am trying to design now. I...

It is fixed I had to replace the heater switch. I pulled the old one out and it was melted. Replaced it with a new one and I have heat again.

On a 1990 runner with a v6 where is the blower motor resistor located?

Either way the bolts on the driver's side are broke off. So if I do put it back on I have to get the rest of the bolts out.

See I wonder that also. I think I need to specify a little. I saw I go through mud every weekend, by that I mean I use it to go through the woods on trails. A little flex would be great. But it is my dd. but I do play in the woods.

Yeah I had a Mazda 3 but I lowered it. There is no comparison.

Could be valve noise. I know they are known for valve noises.

I have been reading up on removing the sway bar, especially the front. Well to be honest mine isn't connected anymore anyway. The bracket on the driver's side is busted. So I am thinking about completely removing it. For as long as I have owned this truck it hasn't been connected. Is this...

The power wires that connect to the motor read nothing on the volt meter. So that shows that I am not getting power to it. I don't want to hot wire it, but I may have to if I can't find a solution. My question is if the switch is bad would that cause no power to the blower motor?

I just don't think it is the motor. I put a volt meter on it and there is nothing there. I have 1990 runner

My blower just quit. It worked one day then the next morning it didn't. There was never a noise like something was wrong. I checked to see if there was power to it and their isn't. So I replaced the relay to make sure but still nothing. Trying to find a fuse for it? Is there something else it...

Or A person can get very creative. My fix: First tank the fuel pump hanger completely out of the fuel tank. Second remove the fuel pump. Third clip the tubes off as close as possible to the plate itself. Fourth remove all the rust from the plate. Fifth drill out the previously cut tubes...

I have a 1990 Toyota 4Runner. It has the v6 and it is 4wd. Here is my issue. I have a fuel leak. I dropped the tank tonight. I know the problem. The piece coming out of the fuel tank that connects to the fuel pump has 2 lines coming out of it. Those lines are rusted with holes in it. Also...