Recent content by marley4runner

cleaned the mass air flow during the rebuild. hmmmmmmmm...... somebody must be able to help.

Mine is actually in the same range, but when it starts cold it higher, int he range that I described, I figured it may be computer driven but it is pretty weird.

Have a 1991 t4r with a 22re 5 speed that I've rebuilt the engine on. I've had some ups and downs with this project but now have it on the road. I've noticed, however, that recently the tach is jumping up and down, particularly at stop lights, it will climb slowly from 1600 rpms to say 2100 and...

I'm continuing to have problems with the 4runner(22re, 5spd, 4x4) rebuilt that I'm working on. To catch everyone up to speed this is where I'm at: I have a 1991 donor body from California, the body is mint but it came with a blown motor. THe control arm in cylinder one got loose and punched a...

Just got the front end off and the bolt that hold the right chain guide on top came undone and is most likely in the bottom of the oil pan. The bottom bolt is also loose. Looks like that bolt got wiggled loose and contributed to the snapped chain. I asked the local toyota guru about this and he...

no troll here, love my yotas, this project represents my fourth and I wouldn't stray anywhere else, but a brand new timing chain breaking after idling for five minutes, I've been running this though my mind all day and haven't been able to make any sense of it. I guess a defective chain is the...

Just pulled the valve cover and the timing chain is broken, I'm lost for words, I just replaced it, i CAN'T EVEN IMAGINE HOW THIS IS POSSIBLE? the truck was at idle when it broke. and the chain was brand new-

Working on an engine transfer, picked up a '91(22re/5spd) that had a control arm get loose and blow a hole in the block. My friend had a rusted out '95 so we swapped in his 22re after doing the timing chain/seals and the back end(pilot bearing, flywheel, pressure plate, clutch plate). We finally...

Thank You Thank you to everyone for your suggestions, I guess I'll begin with the thermostat and work from there, hopefully it's not the radiator but the way the coolant sprayed out a pin hole leak sounds like it might be a logical guess. But I really appreciate everyone's recommendations.

Have a '88 4runner that randomly overheated I think while driving it the other day. Typical steam started coming out ront left of the hood and when I pulled over and popped the hood the coolant was all over the inside, mostly down towards the front driver's side wheel well. In looking for a leak...