2003 V8 p0031 code, replaced sensor now get p0032

[tacoma747]

Just as the title states, 2003 V8 4runner, replaced a/f sensor because of a p0031 for and how get a p0032 that won't go away (comes back instantly if it is cleared).

I used a A/F direct from Toyota

Thanks for any advice.

 

[djkurious]

Have you cleaned the MAF sensor? Also, did you replace the a/f sensor with a denso a/f sensor?

 

[tacoma747]

Have you cleaned the MAF sensor? Also, did you replace the a/f sensor with a denso a/f sensor?

Toyota sensor (so yes, denso). I have not cleaned the MAF, I had found that suggestion somewhere but have not done it yet, I did pull it one day and it actually appeared very clean, that is next on the list though.

 

[tacoma747]

Have you cleaned the MAF sensor? Also, did you replace the a/f sensor with a denso a/f sensor?

I finally cleaned the MAF, cleared the code with a scanner and the code came back after about 5 seconds when I started it.

 

[tacoma747]

I checked and do have 12 volts at the plug. Not sure if I have a good ground or not. I wish I knew which wire going into the ECM was the wire coming from the heater so I could check for a broken wire.