deerhunter
New member
No. they just pull the old needle bearing a drop a new one in.
It's most likely not the permanent fix as the root of the problem tends to be a casting issue with the carrier.. (ongoing issue for many years)
Carrier assembly most likely = entire diff in Toyota dealer/tech parlance. I really doubt that they would want techs busting open the clam shell and dealing with backlash pre load and all that jazz. Too much precision required for a dealer tech... they only do that at the factory....
I guess it could be on a case by case basis, depending on the dealership's decision. The dealer that I went to replaced the entire front differential carrier assy, part number: 41110-35A91 under warranty.
I do have a 3" lift kit and differential drop kit installed, I really don't think that the lift kit caused the needle bearing issues; from my understanding the diff drop kit should correct the axle angle. When I looked under my truck, it looks like the dealer did a good job on replacing my front diff and re-installing the front diff drop. The technician did not make any comments about my lift kit, but recommended that I use genuine Toyota gear oil in my new diff, however, I plan on using Mobile1 synthetic instead.