Well that was quick. Emailed AJT and they replied with two options that would work:
Keeps Backup key:
Products | ajt-design
No backup key:
Products | ajt-design
FYI I posted this info a page ago. But good on you for providing the links.
Well that was quick. Emailed AJT and they replied with two options that would work:
Keeps Backup key:
Products | ajt-design
No backup key:
Products | ajt-design
The sensor looks fairly slim, and wires run up towards the electronics in the engine bay. There should be enough room for a winch mounted in the grill. The lower bumper looks like it might support the area below the sensor, so cutting the lower bumper might require an additional bracket or two to secure the grill.
Is there a "go-to" aftermarket remote starter that uses the factory fob?
I have some bad news for you non-pro owners-to-be looking to install the pro grille + garnish. The grille fits fine, but the garnish...
It doesn't fit without modification.
The TSS sensor box protrudes about a quarter of an inch from the lower grille, which prevents you from putting the garnish piece on.
There's probably a new part number, which, like the rest of the 2020 parts, isn't available yet.
Hope this helps anyone else that was hoping to use an older pro grille kit on their 2020.
Has anybody played with the Toyota app yet? For unlocking and remote start for the runner. Wondering if it works well.
Posted this a few weeks back when I picked up my 20202.... Yes, the app works fine for remote starting, locking/unlocking doors. It will tell you which doors are open, even the hood. If they're locked/unlocked. And an approximate how much gas you have left.
I believe for the remote start and locking features through the app, there's a 1 year Toyota Connect trial that's included with purchase. After that, I'm assuming those features are disabled and you'd have to pay $80 p/year if you want to keep it.
Did you have to drive your Delorean to the dealership to get that 20202?
Did you have to drive your Delorean to the dealership to get that 20202?
The folks in 20202 are still wondering when the 6th gen will be released...
This is exactly what I feared. I think we were all assuming an easy fit because the radar box was integrated into the lower part of the grille. Turns out is wasn’t irrelevant.
Does anyone know of anyone who has had this mod carried out by an actual dealer? I’m wondering if even they might be unable to do it.
Sounds like it’s gonna require a 2020 Pro/heritage grille piece to turn a non-
Pro into a non-pro with a heritage grille. The pre-2020s that might be lying around in dealerships won’t cut it.
Do you guys think an aftermarket bumper like the C4 Fab will still work with the radar box right below the grill? Or the AJT TSS relocation bracket can even be used for this?
We believe the full height bull bar and no bull bar options will work fine with the sensor, but we have not verified yet. We will not be getting a 2020 at our local dealer until end of November.
I mean, you can cut the notch out and sand it to a nice finish yourself in probably five minutes with a dremel and a bit of automotive sandpaper. It's on the bottom so even if you didn't take your time, you'd likely never even see it.
Do you guys think an aftermarket bumper like the C4 Fab will still work with the radar box right below the grill? Or the AJT TSS relocation bracket can even be used for this?
![]()
Did you have to drive your Delorean to the dealership to get that 20202?
As a matter of fact...