22RE no longer starting

[nevada]

Only took a week but finally got around to testing the fuel pressure and it's looking like a new pump might be in my future. Here's what I got at the cold start injector and the inlet to the fuel filter.

So unless there's something else I need to check first I'm getting a new fuel pump....

yeah, that's definitely not enough pressure. the good news is these pumps are easy to change with the access panel under the rear seat.

 

[wallytoo]

pump is likely done. i know, i went through 7 or 8 pumps about three years ago. best mod i made was to install a pressure gauge at the CSI.

 

[yinger]

pump is likely done. i know, i went through 7 or 8 pumps about three years ago. best mod i made was to install a pressure gauge at the CSI.

Yeesh. I may just do the same. What setup did you use?

 

[wallytoo]

Yeesh. I may just do the same. What setup did you use?

i purchased an adapter to replace the union bolt from lc engineering, and a liquid gauge from northern tool.

 

[yinger]

Got it running again!

Put a new fuel pump in it and the psi went right to 44 (top of spec per the FSM). Still didn't want to start until I got the body grounded to the block. Used a jumper cable to do it and as soon as I took it off it stalled out immediately, so I just need to fix that permanently.

Thanks again for the help everyone!

 

[RAD4Runner]

Good catch on the fuel pressure!

Like Wallytoo, I also installed fuel pressure gage... mostly same parts, I think.
My Write-up here.

I'd really like to replace it with electrical sender and display in dash, but that's low in list of priorities.