4 Rigid Lights, one switch, Shrockworks Relay distribution install

[TPz_Fuchs]

Very nice write up. I have the single mount and Bussmann sitting on the shelf, but due to funding issues...

I did build my own cables, that was not too difficult, cheap too, had I gone to the local electronics supply place instead of amazon.

As to all of the supplied wires, has anyone thought about getting the removal tool and some cavity plugs. Remove the wires, save them, plug the cavity until you need them.

Currently trying to figure how many relay/switch & any fused leads to run into the cab. I might want a switched relay operated something in the engine bay.

 

[Bugser]

1) combo
2) zero issues. I would do it the same way all over again.

Wondering if the AOB switches are still holding up? Have heard mixed reviews.

I did order 5 AOB switches for my 18 ORP.....have empty blanks, all on the dash, like you, it will make for a clean stock looking mod.

Really have been vacillating between the Shrockworks Bussman block and the Switch-Pros 9100. The 9100 has its own set of switches, looks very nice, easy install but it looks aftermarket IMHO. It looks good, just not similar in appearance to the Toyota switches.

The only thing holding me back are these switches. I am a ham op and have lots of tools and thought I 'd put the switches on the bench and test repeatedly with a 12v supply to check for reliability.