HelpMeFixIt
New member
Question...
How to test for floating valve?
Can you replace valve springs without pulling the heads on this motor?
How to test for floating valve?
Can you replace valve springs without pulling the heads on this motor?
And verify ignition timing with an olde fashioned timing light? Rev it up and see if something weird happens at 3500 rpm.
I once had a 280zx that i stupidly washed its engine, then it would not operate above about 2500rpm. Took it to a real mechanic and he said an electronic RPM limiter had gotten shorted out with the water. Because it didn't work, the ecm limited the rpm to that level. Not sure what is causing your issues, but if i were you I'd seek a professional mechanic I trust. I mean i can appreciate the "lets fix it ourselves" bit but at a certain point ya' gotta move on to bigger and better issues. Luck!
its a 98 so it only had the single cat right? and did you check whether or not more exhaust was flowing after you dropped it all? also no PO420 code yet? might be redundant but the more info the better!
and just to clarify, 3500 rpm no matter what? (i.e., driving, revving in neutral/park)
just searched this problem, one guy said to try checking grounds on the injectors, if they all don't work at 3500 rpm then something is shutting them off.
kinked fuel line causing not enough fuel for 3500 rpm? plugged/kinked/blocked hoses?
those are all the guesses I have for now. Good luck!
Igniter tested, but unsure of results given the instructions I found so we ordered a replacement for $20 from ebay.
Manually validated the timing with dowel rod in piston 1 spark plug tunnel.
Compared to both cam pulleys and everything lines up.
Crank pulley was at zero degree mark with all lined up.
If igniter doesnt do it, we dont know where else to turn. We've replaced just about everything.
Fuel pressure regulator was replaced too.
Any and all help/suggestions are greatly appreciated before we :gun4: to the truck .....
Maybe the egr valve stuck open?
This is a LONG shot. Check the 20 amp EFI fuse. I had a 01 that had similar symptoms. Turned out one leg of the fuse was broken/burnt. Replacement solved the problem. I doubt it but check the fuse anyway.
No EGR on OBDII 3.4L (post '96) 5VZ engines.