Anyone mount Rotopax under the truck?

[T4topher]

Seems like the reason you didn’t tuck it up higher was because it doesn’t really fit in the space between the two body/sheet metal cross members. Probably wouldn’t want to cut into that much unless you reinforce it after.. I’m going to take some measurements..

 

[kolelt]

Seems like the reason you didn’t tuck it up higher was because it doesn’t really fit in the space between the two body/sheet metal cross members. Probably wouldn’t want to cut into that much unless you reinforce it after.. I’m going to take some measurements..

That’s why I was saying if he would of did that side just like the opposite side. It would tuck the cans up more. You know what I’m saying ? Basically U shaped to take the contour of the body. No need to cut anything.

 

[T4topher]

That’s why I was saying if he would of did that side just like the opposite side. It would tuck the cans up more. You know what I’m saying ? Basically U shaped to take the contour of the body. No need to cut anything.

Ah I see what your saying lay it flat instead of angled. Yea I think your right, that would work better.

 

[kolelt]

Ah I see what your saying lay it flat instead of angled. Yea I think your right, that would work better.

Yes sir. It’s little hard to try to draw a picture through words lol.

 

[kolelt]

Wondering about the rear tire cross member being removed. Wonder how structurally it is.

 

[T4topher]

Wondering about the rear tire cross member being removed. Wonder how structurally it is.

I’d say it’s definitely structural, if I were to do this I would weld a bar across either before or after the rotopax. Especially since I have a rear bumper w/ tire swingout.