ARB Drawers RF1045US

[nickmatt]

I am planning on removing the sliding tray on my 2010 Trail and am in the market for some drawers.

Is anyone using ARB Drawers RF1045US? (width for two side by side is 42.12")

Ive seen a few members using RF945US (width for two side by side is 39.76"), however the width between the wheel wells in the back has been measured at 44". Using the RF945 leaves a gap in between the side of the drawers and the wheel well, so there should be enough room for the RF1045.

The RF945 is 37.2" long, and the RF1045 is 41.14".Will this be too long and hit the back seats? I would measure on my 4runner but it is in the shop until next week, and I would really like to get these ordered before then.

Any help is greatly appreciated!

 

[joneseyyy]

The 1045s will be too large. I have the 945s check on here or dirtroadtrip.com for reviews and install details.

 

[Hellamatic]

Just fab a set on your own drawers - couple bucks in material and some rudimentary carpentry skills will have you on your way. I had mine designed, fabricated, covered in marine grade carpet, and installed in the truck in about 4 hours or so.

 

[Doc_Fry]

Chec out Adventure Trailers Drawers too. They have a nice alternative to the Australian and South African Drawer Systems without the extra shipping.