Are there any secrets to removing the switch blanks without removing the dash?

[2021nightshade4x4]

The plan, if I can, is to pop it out the front, fish a wire down to the footwell where I can decide how to route it, then snap the new switch in. 2021 Nightshade.


Sent from my iPhone using Tapatalk

 

[jawkdna]

Which Blanks? It should take you about 2 second to open up the dash to get to most of them...

 

[[email protected]]

Most can be popped but just putting your hand up there.

 

[2021nightshade4x4]

Which Blanks? It should take you about 2 second to open up the dash to get to most of them...

Looks simple enough, tool-less!


Sent from my iPhone using Tapatalk

 

[Sully888]

I usually use either a plastic pry bar, or a screw driver with duct tape on it and it just snaps off.

 

[NYRunner]

They pop out easily, and that’s where I put the controller for my Sprint Booster! I popped one of the blanks out, threaded the controller through from the back and used a little double sided tape to hold it in place…