Charlievee
Senior Member
Anyone find the dimensions of these? Looking for the center to center of the mounting holes.
Banana Holder NOW AVAILABLE
- Thread starter Victory 4x4
- Start date
Globetrotter78
New member
Victory banana holder still avail? If so, Im in!
Walletclan
New member
My only concern is that in Texas, produce cannot be visible in vehicles. All bananas must be concealed and this might not qualify.
But thank you for thinking about my banana!
But thank you for thinking about my banana!
RichinRidgewood
New member
If you have a banana from 1911 will it fit?
Victory 4x4
Official Vendor
Sure! If you also have a 1.5" belt clip holster for that banana.
Charlievee
Senior Member
"The two widest mounting holes (the bottom two) are 14" apart. The MOLLE holes are 1.5" x 1.125" and will fit standard MOLLE accessories."
Charlievee
Senior Member
Got the name or link for said plastic plugs?
Charlievee
Senior Member
Got one in. Couple of things to note.
-I had to use a make shift brake and put two small bends in the panel IOT fit the contour of the center console better. I"m guess this is why there are no pics from top down.
- i took the console apart, used nuts and washers to secure it. This required drilling out the mounting holes and was a small PITA.
- not all U.S. G.I. molle attachments are compatible. Mostly the plastic parts that are designed for the webbing of the LBE and not 1/8" thick metal. Kind of a let down as there are tons of kewl guy attachments out there and in the bottom of many of my tuff boxes. You can weave the USGI webbing into the panel, but the non milspec makes it difficult to get them tight. Kit/pouches with the old ALICE clips would be a better fit. Belt clips of course work fine.
All in all, not a terrible mod and should be very versatile going forward.
One last note. If you plan to use the nut/bolt attachment idea. Slide the panel back toward the seat about a 1/4". This will avoid the molded plastic support structure molded into the center console.
Just my .02
-I had to use a make shift brake and put two small bends in the panel IOT fit the contour of the center console better. I"m guess this is why there are no pics from top down.
- i took the console apart, used nuts and washers to secure it. This required drilling out the mounting holes and was a small PITA.
- not all U.S. G.I. molle attachments are compatible. Mostly the plastic parts that are designed for the webbing of the LBE and not 1/8" thick metal. Kind of a let down as there are tons of kewl guy attachments out there and in the bottom of many of my tuff boxes. You can weave the USGI webbing into the panel, but the non milspec makes it difficult to get them tight. Kit/pouches with the old ALICE clips would be a better fit. Belt clips of course work fine.
All in all, not a terrible mod and should be very versatile going forward.
One last note. If you plan to use the nut/bolt attachment idea. Slide the panel back toward the seat about a 1/4". This will avoid the molded plastic support structure molded into the center console.
Just my .02
Attachments
Last edited:
david05111
New member
If that thing could legally hold a “banana” in FL, I’d be all over one. Cool product
Similar threads
