oljedi11950
New member
So did the bent pin for drl's works , however my drivers side high isn't coming on ? So bent it back & of course it works ! So question is wtf ?
Drl & high problem ?
- Thread starter oljedi11950
- Start date
Register to hide this ad
oljedi11950
New member
Drl & high beam
Fugon dumb ol man ! Bent wrong pin muron , bent from big pin not other side ok nice talk bye !
Fugon dumb ol man ! Bent wrong pin muron , bent from big pin not other side ok nice talk bye !
oljedi11950
New member
Thx Saker , still not sure if I'm doing this right way ? Need to investigate why my high aren't coming on .
Saker
Senior Member
Did you check your high beam fuse? IIRC, there is one in the engine COMP fuse box.
oljedi11950
New member
No sir ! Will do, highs work when straighten pin & replug so, either that or as previously stated I'm a fugon muron ! Going with that :doh:
Saker
Senior Member
Oh damn, more than likely not a fuse then.
oljedi11950
New member
Yep not sure but done fugin with it , don't want to bend pins anymore & not have high beams ! Further investigation
Similar threads
