versolalto
New member
Complete manual hub conversion set up for 3rd gen 4runner. Came off of a 1996 tacoma.
Includes:
manual hub CV axles
2 hubs
2 spindles with knuckles.
All hardware is present, and most seals and gaskets are in reusable shape if that is the route you chose to go.
Knuckles were torched/sawzalled off as I intended to use the spindle in the 4runner knuckles to retain ABS. These were sourced when I was living in Pittsburgh, PA last year so there is a decent bit of surface rust on the spindles. With a cross country move and first kid I haven't gotten around to dressing them up. Hubs were cleaned and painted. Selling because I am selling my 4runner - need more car seat room in rear seat
Asking $500. Local pick up only - unless you are ok paying astronomical shipping costs due to the weight of it all :barf: Thanks
Includes:
manual hub CV axles
2 hubs
2 spindles with knuckles.
All hardware is present, and most seals and gaskets are in reusable shape if that is the route you chose to go.
Knuckles were torched/sawzalled off as I intended to use the spindle in the 4runner knuckles to retain ABS. These were sourced when I was living in Pittsburgh, PA last year so there is a decent bit of surface rust on the spindles. With a cross country move and first kid I haven't gotten around to dressing them up. Hubs were cleaned and painted. Selling because I am selling my 4runner - need more car seat room in rear seat
Asking $500. Local pick up only - unless you are ok paying astronomical shipping costs due to the weight of it all :barf: Thanks
