FS 4th gen Flowmaster Exhaust NE PA

[Boxermachine]

Up for grabs is my Flowmaster muffler and Flowmaster resonator, all welded and solid. Used for 1 year. Ready to bolt on. Sounded great, deep, not too loud. Willing to ship, but may be expensive. Looking for $200 near 18661.

4runner flow - Album on Imgur
4runner flow - Album on Imgur

 

[Boxermachine]

Was on a 2004 v6, should work just fine on the v8.

 

[Boxermachine]

anyone, shoot me an offer, really sounds nice and is extremely solid.

 

[Flash Runner]

anyone, shoot me an offer, really sounds nice and is extremely solid.

I just ran into a an exhaust problem (my tail pipe snapped off from my muffler) This might be a cheaper fix (and I was wanting to upgrade anyway). I'll PM after I get repair estimates to compare costs too. Mind checking the shipping cost for me since you'll have the dimensions? 40503

 

[Boxermachine]

 

[Boxermachine]

$200 shipped?? Anyone??

 

[techno]

Interested. Can I ask why you're selling?

 

[Boxermachine]

bump:girl:

 

[Boxermachine]

bump

 

[Boxermachine]

yellow bikini bump

 

[T4RWheelin]

So would thus just bolt on behind intermediate pipe?

 

[DZNUTS]

Why would you weld a flow master middle into your exhaust system and retain the original muffler [emoji848]


Sent from my iPhone using Tapatalk

 

[T4RWheelin]

i meant is it build like a cat back system, you wouldn't bolt the muffler right on in the middle at a low point. Where my stock muffler gets scratches and dings from rocks where it is, i wouldn't out it any lower, or farther from the rear axle.

 

[Boxermachine]

It replaces the stock muffler, bolts right up, and yes, it give a bit more clearance than the stock muffler, as it is flatter. email me if you're interested boxermachine at gmail dot com

 

[Boxermachine]

bump again

 

[Boxermachine]

Merry Christmas bumpo

 

[Boxermachine]

bump, still looking to sell it!

 

[Boxermachine]

 

[Boxermachine]

bikini bump

 

[Boxermachine]

Bump, c'mon make me an offer!