Good place in North DFW for 5100 Install?

[KP Texan]

Can anyone recommend a good shop in the DFW area (the closer to McKinney, the better) that knows 4Runners and can install some front Bilstein 5100s w/alignment?

Probably have the tools and experience to do this myself but, with two small kids, time is at a premium!

Thanks for any input you guys have!

 

[OkieMedic]

Its too easy to pay someone to do.... Just go rent a spring compressor and get it done! I started mine at 8 in the morning after getting off a 12 hour night shift. Was done by noon-ish. Would have been quicker had I not been absolutely exhausted.

 

[tx_shooter]

I actually filmed my friend pulling struts off a second gen Tacoma a few weeks ago. He did the driver side install in 8 minutes. The whole process (excluding the spring swap) took a whole 40 minutes.

He does work for beer sometimes. @tex

 

[Dallas_T4R]

Can anyone recommend a good shop in the DFW area (the closer to McKinney, the better) that knows 4Runners and can install some front Bilstein 5100s w/alignment?

Probably have the tools and experience to do this myself but, with two small kids, time is at a premium!

Thanks for any input you guys have!

Not sure if you ever got an answer, but I hear Baertrax does good work.

 

[CowboyTaco]

I actually filmed my friend pulling struts off a second gen Tacoma a few weeks ago. He did the driver side install in 8 minutes. The whole process (excluding the spring swap) took a whole 40 minutes.

He does work for beer sometimes. @tex

He's [MENTION=99406]yotantexas[/MENTION] on this forum. My garage is also generally available for the same low, low price of Beer. However, neither of us do alignments and OP is in McKinney....Kind of a haul to NFW or Arlington.

 

[KP Texan]

Thanks for the replies everyone! Actually ended up doing this myself a couple months back. The install went just fine but, since I was being careful with what I was doing, it took me a while. I could probably do it much quicker a second time around!