Guess what came today?
- Thread starter MillerPKA
- Start date
Register to hide this ad
proudrunner
New member
Cool! would like to see some nite pics!
FoneRunner
New member
:lmao:
CeliRunnerGirl
New member
Im rolling on the ground this was my first thought too!!
But for real post some pictures when ya get them in!!!
brian2sun
Elite Member
Classic.:bravo:
MillerPKA
New member
haha those are the guts of the headlight. The lens is really clear I'm finishing wiring right now, sometimes the poor Chinese translations are confusing but I'm getting there. Should have night pics in a little but I can't do too much else because the interior is gutted at the moment.
MillerPKA
New member
Yeah they will technically but you won't get near the results you'd like with the frosted lens, you can buy ebay replacements as long as the seal is good because these reflect internally and do not rely on the housing itself. almost done wiring about to go mount them all up should take about 30 min
96743runner
New member
Sweet! I'm curious to see the finished product too.
Wow everything came in pretty quickly. How did my write up workout so far. I have to get ready for work, but if you haven't go it by tonight I will help you out. Just make sure each side goes like this. Power wire with fuse holder straight to the battery, ground gets grounded on the body, two black and yellow connectors from projector get connected to the ballast, cylinder like connector from the projector goes the same connector from the harness, H4 plus from harness gets plugged into stock headlight plug. I'll check back after work.
MillerPKA
New member
I'll be working on this around 11 for a couple hours in between classes I'll let you know what I find, I thought I did everything right the plugs were simple, but I was working on my car for 6 hours before I even started these so I could have just been a little loopy.
I've been trying a side at a time.....do they both have to be fully plugged in for them to work?
I've been trying a side at a time.....do they both have to be fully plugged in for them to work?
Last edited:
BTO
Member
It looks like everything including the kitchen sink.
MillerPKA
New member
No cutting or drilling. I got a white halo but you can get blue red and green as well.
Help me out here. Last night I could only get the halos to work. Went out there this morning and neither halo or hid worked. Turned the corner lights on and nothing, checked the fuses, everything was fine except the tail was blown, which was apparently cutting power to the whole lighting system. Replaced it with an extra one and voila tails corners and halos all working again. hid's are still not working. Both head (l) and head (r) fuses seem to be ok, there is a big ass fuse right next to it labeled head, could it be that this one is messed up? Double checked all wiring grounds and connections its correct. Confused right now
Help me out here. Last night I could only get the halos to work. Went out there this morning and neither halo or hid worked. Turned the corner lights on and nothing, checked the fuses, everything was fine except the tail was blown, which was apparently cutting power to the whole lighting system. Replaced it with an extra one and voila tails corners and halos all working again. hid's are still not working. Both head (l) and head (r) fuses seem to be ok, there is a big ass fuse right next to it labeled head, could it be that this one is messed up? Double checked all wiring grounds and connections its correct. Confused right now
MillerPKA
New member
Haha I'm an idiot the wire going to the ballast fits in both right side up and upside down, its just a 2 pronged ellipse...theres an engraved '+' signifying the red wire should be on that side but I didn't pay attention,l just lucked out and put both in backwards, we're good!
