Help - Bulb Identification

[0verland]

So I am replacing my HVAC bulbs since over half of them are out and want to go LED. Can anyone help me identify which bulbs are needed.

This is the kit sold by Toyota, however there is no mention of the sizes.

I planned on replacing them with these bulbs here as they have been linked a few times throughout the forums but no clear indication on which ones are needed.

Any help or insight to an alternative product would be greatly appreciated.

 

[Slowgoat]

Pretty sure this is what I bought: T-1 bulbs.

Been six months so far and no issues. They’re cheap, and I still have 8 left!

http://www.amazon.com/dp/B00L8BR76A

 

[blackjackck]

Bulb Answer

So I am replacing my HVAC bulbs since over half of them are out and want to go LED. Can anyone help me identify which bulbs are needed.

This is the kit sold by Toyota, however there is no mention of the sizes.

I planned on replacing them with these bulbs here as they have been linked a few times throughout the forums but no clear indication on which ones are needed.

Any help or insight to an alternative product would be greatly appreciated.

For the TOP 3 on the left = 3mm T1 bulbs
For the BOTTOM 2 on the right = 3mm T1 bulbs
For the BOTTOM 3 on the Left = 4mm

The 3mm bulbs lights and looks good. The base is a smidge bigger so you have to massage the bulb in.

The 4mm is a little complicated. From reading everyone's comments on this forum, these bulbs needs 12v but the LCD screen only provide 7v which means they don't light up(which is where I'm at today). I also gathered that these bulbs have polarity so when I get a chance I'll take them out and rotate them 180 degrees and see if they light up.

Here's the earlier post from a week ago, my picture of the HVAC is there.

superbrightleds

 

[0verland]

For the TOP 3 on the left = 3mm T1 bulbs
For the BOTTOM 2 on the right = 3mm T1 bulbs
For the BOTTOM 3 on the Left = 4mm

The 3mm bulbs lights and looks good. The base is a smidge bigger so you have to massage the bulb in.

The 4mm is a little complicated. From reading everyone's comments on this forum, these bulbs needs 12v but the LCD screen only provide 7v which means they don't light up(which is where I'm at today). I also gathered that these bulbs have polarity so when I get a chance I'll take them out and rotate them 180 degrees and see if they light up.

Here's the earlier post from a week ago, my picture of the HVAC is there.

superbrightleds

Awesome! I just order some up. Hopefully they work well. Should be here in about a week and I'll report back.