Help request for Daystar Lift - Front Brake Bracket

[generald]

Hi all,

After lots of searching, I cannot find a solution.

Vehicle: 2016 4Runner Limited (with XREAS)

Spacer Lift: Daystar, Toyota 4Runner 2.5" (front) + 1.5" (rear) Lift Kit (Model: KT09134BK)

Issue: Front brake line bracket that attaches to vertical arm does not align with bolt holes. Issue appears that the hard brake lines are preventing alignment. Pictures below.

Attempts: Jacked up the lower control arm to change the angle, no improvement.

May I please ask for your help -- any ideas?

Thank you in advance, T

 

[MyanRagahis]

Kind of looks like it got straightened out.
Here is what mine looks like. More of a bend to it.

 

[pDubs]

You should just be able to move it with your hand and put a slight bend in the hard line.

 

[generald]

Really appreciate you both. Been a tough weekend and your pics+feedback is that support I needed. Will get back to it tonight.

Many thanks, T

Kind of looks like it got straightened out.
Here is what mine looks like. More of a bend to it.

You should just be able to move it with your hand and put a slight bend in the hard line.

 

[Sniper4690]

Hi all,

After lots of searching, I cannot find a solution.

Vehicle: 2016 4Runner Limited (with XREAS)

Spacer Lift: Daystar, Toyota 4Runner 2.5" (front) + 1.5" (rear) Lift Kit (Model: KT09134BK)

Issue: Front brake line bracket that attaches to vertical arm does not align with bolt holes. Issue appears that the hard brake lines are preventing alignment. Pictures below.

Attempts: Jacked up the lower control arm to change the angle, no improvement.

May I please ask for your help -- any ideas?

Thank you in advance, T

I'm sorry to revive quite an old thread but I've been trying to figure out what that bolt is that attaches that bracket to the arm like that. I just replaced my front brake pads and rotors and one of them screws stripped out and I've been looking everywhere for it. I own a 2020 4Runner

 

[generald]

I'm sorry to revive quite an old thread but I've been trying to figure out what that bolt is that attaches that bracket to the arm like that. I just replaced my front brake pads and rotors and one of them screws stripped out and I've been looking everywhere for it. I own a 2020 4Runner

I think it’s an M8x20

See Part number for brake bracket bolt?

You could retap it for whatever tap you have one or two sizes larger.

 

[Sniper4690]

Oh man thank you so much! I've spent so long trying to find out what that bolt is. I think I might have that on hand since I went to O'Reiley's and they helped me out as well (I just haven't tried them yet because it was a fairly long day). Might get a few extra though and probably a tap and die set too while I'm at it.