TeryT
New member
This one I wonder about. I'm a fairly technical guy who has read technical preventative & predictive maintenance writings on this for almost 3 decades. One of the roughest things you can do to any device is to start it up. This pertains to both electrical & mechanical things.Thai said:Ok...i am guilty...i GOOGLED:
Idling Myth No. 3: Shutting off and restarting your vehicle is hard on the engine and uses more fuel.
Frequent restarting has little impact on engine components such as the battery and starter motor. Component wear-and-tear caused by restarting the engine is estimated to add $10 per year to the cost of driving - money that will likely be recovered several times over in fuel savings from reduced idling.
As a rule of thumb, if you are going to be stopped for 10 seconds or more, except in traffic, turn your engine off. (Source: Natural Resources Canada.)"
In electrical things, when you turn them on, there is a sudden rush of current. This rush of current causes the component to go from one temperature to a higher one quite suddenly. This produces stress. Ever notice a light bulb blowing out when you first turn it on? It often makes an audible noise as its "life" is ended! (Some electrical motors can be designed to run tens of thousands of hours on continuous run. How? Because they don't have to start & stop.)
A mechanical device is overcoming dead stop inertia. There is, as a matter of physics, considerable stress put on the various components as they go from a dead stop to high RPM.
In an electric motor you have an electro-mechanical device. In this situation, both electrical & mechanical factors apply. In a gasoline engine, it is primarily the mechanical inertia to overcome from a dead stop (but the starter experiences both).
I can appreciate the studies done showing that idling causes other detrimental things to occur. I'm not arguing that. Certainly, at some point, long-term idling makes no sense. I'm just wanting to point out reasons why constantly starting an engine might not be prudent.
Now back to the original question. Modern engine oils are such superior lubricators that many of the practices of years gone by are negated. I'm not expert on lubrication, but I've read many times that the additives in modern oils do a much better job of keeping the cylinder walls lubricated, even while the engine is shut down. This is even more true with a true synthetic oil. Therefore it is not as critical to ensure oil has thoroughly lubricated the cylinder wall with fresh oil on start up.
Many think that our current gasser engines are built far superior to ones from years ago. While it certainly may be true that there have been good progress in this area, I've also read many times that engine longevity is due primarily to the advances in oil additive technology.