Interior carbon fiber kits

[N2GLOCK]

Anyone dealt with this company before? 2012 Toyota 4Runner Wood Grain Dash Kits | Carbon Fiber

They make various kits for the 5th gen T4R and various other vehicles. I was just looking at some ways to liven up the interior a bit and found this site. Looks like they even offer exterior pre-cut pieces as well.

 

[Mason]

I don't care what none of y'all say, but that steering wheel option looks really nice.

 

[eddiebx]

Anyone dealt with this company before? 2012 Toyota 4Runner Wood Grain Dash Kits | Carbon Fiber

They make various kits for the 5th gen T4R and various other vehicles. I was just looking at some ways to liven up the interior a bit and found this site. Looks like they even offer exterior pre-cut pieces as well.

The pre-cut ones might look a bit cheesy because it doesn't provide 100% coverage and you can see the edge...perhaps if you picked up a roll of 3M vinyl in whatever pattern and just hand wrapped it, it will come out much nicer looking since you can tuck the edges under the panels

Or if you've got deep pockets, look into hydro dipping: Water Transfer Printing / HydroGraphics / Camo Dipping

 

[DannyLlama]

[MENTION=85537]Lolrax[/MENTION] did something similar, along with other options discussed here:

http://www.toyota-4runner.org/5th-gen-t4rs/145066-dinoc-woodgrain-dash-attempt.html

 

[pacho]

for those who are wondering, the dashboard on my 2014 2WD SR5 has a "carbon-fiberish" look or texture(Im serious). its hard to describe- the dash is covered by little indentations like a golf ball, and its in dark grayish color. it was like that when I bought it. I dont know if its like that for other 2014 SR5s or Trail/limited.

 

[diverscale]

At first glance, I thought it replaced the entire trims, but after reading eddiebx's post, I noticed they look like covers, using 3M afhdsive to be held into place. It would have interested me if it had replaced the entire trim.

 

[barryhiram]

Caution Will Robinson, caution, you're dangerously close to http://www.toyota-4runner.org/5th-gen-t4rs/162058-bad-idea-mods-3.html..........................:behindsofa:

Another option - Hydrographics K & K Kustomz Hydrographics- Welcome, but I'm sure it's $$$$$$$$. Sure looks sweet though

 

[barryhiram]

Or if you've got deep pockets, look into hydro dipping: Water Transfer Printing / HydroGraphics / Camo Dipping

D'oh..........didn't read your full post eddiebx, my bad :ybrick:

 

[JayceeP]

I don't care what none of y'all say, but that steering wheel option looks really nice.

It does, but not for $300.

 

[N2GLOCK]

Wow, thanks to everyone who posted about the hydrographic, water transfer deal. I had no Idea that even existed. I've been watching videos all afternoon on this technique using a DIY kit. Looks easy but also requires alot of patience. This would be a perfect option for me as I don't wanna do all the silver pieces, just some of them. There are also alot more options as far as patterns go. I may even end up doing the front and rear Toyota emblems too.