Antpwr
New member
ok working on my adjustable panhard bar because i refuse to spend 175+ for one from another shop, my problem is i am trying to decide between 2 things.
1. 5/8 x18 threaded poly bushing with 1.25" .120" wall DOM
2. 3/4 x 16 thread poly bushing with 1.5" .250" wall DOM
I will be using the poly bushings on both ends only problem with that is that they are both right hand thread so on car adjusting is not so easy would have to drop one end to adjust, as opposed to using regular rod ends where i could go right and left hand threads. I want to use the poly to keep the ride and noise as close to factory, this is still a daily driver. any input would be great, just dont really know if the smaller choice would be too small or if the bigger size is just right or overkill.
oh yeah if you are wondering option 1 is about 78.00 and option 2 is about 100
1. 5/8 x18 threaded poly bushing with 1.25" .120" wall DOM
2. 3/4 x 16 thread poly bushing with 1.5" .250" wall DOM
I will be using the poly bushings on both ends only problem with that is that they are both right hand thread so on car adjusting is not so easy would have to drop one end to adjust, as opposed to using regular rod ends where i could go right and left hand threads. I want to use the poly to keep the ride and noise as close to factory, this is still a daily driver. any input would be great, just dont really know if the smaller choice would be too small or if the bigger size is just right or overkill.
oh yeah if you are wondering option 1 is about 78.00 and option 2 is about 100
Last edited:
