r1verf3nix
New member
Finally got around to getting mine on. Can I say first Cement Pro with it? Looks great, and with the combined weight of roughly 100lbs it actually doesn't effect the front height as much as I expected.
New Warn Semi-Hidden Winch Kit bumpers
- Thread starter sn_85
- Start date
Finally got around to getting mine on. Can I say first Cement Pro with it? Looks great, and with the combined weight of roughly 100lbs it actually doesn't effect the front height as much as I expected.
That does look good. Really good. What did you use to cut the bumper a dremel?
ToyoT4R
Member
Combined weight of bumper and winch is just 100lbs?
That seems off to me. IIRC, the bumper alone runs about 80lbs and a winch goes about the same.
r1verf3nix
New member
Sorry my math was just a bit off. 80 lbs bumper plus 70 lbs winch. Still the front isn’t as dipped down as I expected.
To the other question, yes a dremmel is the way to go. The kit doesn’t come with any trim cover for the cut line so go to a auto parts store and get some. It looks bad without it.
So, after being told last week by Summit that my bumper would ship by the end of last week, early this week, I still haven't seen a shipping notice yet
I called today to check on it and now I'm being told that Warn hasn't built them yet and they wouldnt be shipping mine until they're built t the end of the month, around March 29th.
I ordered mine early/mid February.
Best part is that Summit's website says if you order one today, it will ship tomorrow!!!
So, you guys who have them apparently they haven't been built yet.
WTF
I called today to check on it and now I'm being told that Warn hasn't built them yet and they wouldnt be shipping mine until they're built t the end of the month, around March 29th.
I ordered mine early/mid February.
Best part is that Summit's website says if you order one today, it will ship tomorrow!!!
So, you guys who have them apparently they haven't been built yet.
WTF
Last edited:
r1verf3nix
New member
I don't believe anyone has done the install with steel cable yet. But from looking at my bumper there is a cutout above the exit point for the lines. I believe fully that a roller fairlead will fit no problems.
It may be better for me to go with synthetic for less weight anyway. Benefit of the roller is ease of mounting a plate. I haven't looked at plate mounts for Hawes style though
explain
RUNTHAT
New member
Nobody is making these '13 Limited/SR5/Trail options.
I ordered dec 22 thru trdpars4u. Then canceled and ordered thru summit on 2/12.
Yeah but I don't understand why
r1verf3nix
New member
Might should have stayed with trdparts4u? Barbara was telling me she had 20 sitting in their warehouse about to go out for shipping, when I picked up mine.
