O2 Sensor Bolts?

[hulk311]

I just installed the much talked about on here DENSO 02 sensor (up front) on my '97 4runner, however the kit did not come with any bolts! Where can I get the stock replacement bolts (the old ones were so rusted that they just feel apart). I put temporary bolts on both sides, however on one side the bolt does not go all the way down to the 02 sensor, leaving a very, very tiny gap between the 02 sensor (and gasket) and the pipe. Will this cause any performance issues or damage to any part of the exhaust?

 

[hulk311]

BUMP!

So who's replaced their 02 sensor and where did you get the O2 sensor replacement bolts?

 

[nyc4runnin]

same thing happened to me on a 99, if the bolt is too long, either cut it, or put some washers or extra nuts as spacers until there's a snug fit. i replaced my cat as well and it used 5/16 bolts i believe...

this was for my rear cat, my front cat's bolts were not rusted ....